Power-jacks C-Series Manual do Utilizador

MAINTENANCE MANUALC-SeriesMachine Screw JackMM-SJCMS-EN-00Operation & Maintenance Instructions with Parts List

10www.powerjacks.com4.1 General Installation Notes4.1.1 Before installing new parts, remove any rust preventative, protection grease etc.4.1.2 Chec

www.powerjacks.com114Installation4.2 GeneralInstructionsforttingdetachableendsonleadscrewsIn most circumstances the screw jack is delivered

12www.powerjacks.comInstallation44.3 Unpacking and installation4.3.1 Remove the C-Series screw jack(s) from their container. Dispose of the packagin

www.powerjacks.com134Installation4.4.11 Drive Motor4.4.11.1 Power Jacks recommend that when you purchase a screw jack requiring a motor mounted dire

14www.powerjacks.comInstallation44.4.13 Limit Switches – Rotary Cam Type (RLS)4.4.13.1 Power Jacks recommend that when you purchase a screw jack req

www.powerjacks.com155Operation5.1 Operational Recommendations5.1.1 Select a screw jack which has a rated capacity greater than the maximum load that

16www.powerjacks.com5 Operation5.2.3 Anti-Backlash Screw Jack – When To Use For reduced axial backlash of the lead screw in the screw jack select a m

www.powerjacks.com175Operation5.2.11 Shock Loads on a Screw Jack Shock loads should be eliminated or reduced to a minimum, if they cannot be avoided,

18www.powerjacks.comOperation55.2.15 Side Loads on a Screw Jack Screw jacks are designed primarily to move and position loads and any side loads (loa

www.powerjacks.com195Operation5.2.21 Corrosion Resistant Properties Screw Jacks can be supplied with alternative materials and/or paint specications

20www.powerjacks.comOperation55.2.28 Connecting Screw Jacks in Series The number of screw jacks that can be connected in series is limited by input t

www.powerjacks.com216Maintenance6.1 General Maintenance Notes6.1.1 Maintenance and replacement work must be done by an expert maintenance technician

22www.powerjacks.com6 Maintenance6.2 Regular MaintenanceAlso refer to section 6.36.2.1 Lubrication Of The Screw Jack6.2.1.1 The screw jacks are shi

www.powerjacks.com236Maintenance6.3.4 Check all bolted joints/couplings for wear, deformation or corrosion and tighten them down fully without over t

24www.powerjacks.com6 Maintenance6.5.8.6 When installing the worm shaft, use shims to establish the correct axial oat for the bearings Installed.6.5

www.powerjacks.com25Maintenance66.9.2.2 Flush a unit’s interior thoroughly with a light solvent before relling with new lubricant.6.9.3 Warning6.9.3

26www.powerjacks.com7 Recommended LubricantsTable 1 - Normal OperationManufacturer LubricantCastrol Spheerol EPL2Esso Beacon EP2Gulf Gulfcrown EP2Mob

www.powerjacks.com278Spare Parts8.1 Recommendations8.1.1 C-Series screw jacks are fully supported by Power Jacks. Spare parts and repairs are availab

28www.powerjacks.com9 Storage & Warehousing9.1 General Storage RecommendationsRecommendations for storing the products are indicated below:9.1.1

www.powerjacks.com2910Disposal of Units10.1 General Disposal Guidance10.1.1 This must only be done by operators trained in the observance of applica

www.powerjacks.comContents3C-SERIESMACHINE SCREW JACKSSPARES LIST & MANUALMM-SJCMS-EN-001 Introduction ...

30www.powerjacks.com11.1 WarrantyDenitionsWhen used in these conditions the following words have the meanings set out opposite them below:Company:

www.powerjacks.com3112General Assembly & Parts List12.1 Parts ListItem DescriptionBase Model Parts 1 Shell (Gearbox Housing)2 Shell Cap3 Worm Sha

1115113530/31141012542383236833346793735791115832www.powerjacks.comGeneral Assembly & Parts List12.2 Rotating12

111511320/21141012425368226792379111585www.powerjacks.com33General Assembly & Parts List12.3 Translating12

1115113520/21141012525355155368542267923791115834www.powerjacks.comGeneral Assembly & Parts List1212.4 Translating Anti-Backlash

57374/75111511371/72141012470536822679237911158www.powerjacks.com3512General Assembly & Parts List12.5 Translating Anti-Rotation (Keyed)

1115113520/21141012525355155368542280738167923791115836www.powerjacks.comGeneral Assembly & Parts List12.6 Translating Anti-Backlash & Anti-R

www.powerjacks.com37General Assembly & Parts List12.7 Accessories & OptionsAnti-BacklashEnd FittingsRotary Limit Switch AdaptorAnti-Rotation

38www.powerjacks.comNotes

4www.powerjacks.com11.1 TranslatingCongurationsIntroductionLead Screw Options1. Standard 1 x Pitch2. 2 x Pitch3. Anti-Rotation (Keyed)4. Stainl

Head OfceBalmacassie Commercial ParkEllonAberdeenshireAB41 8BXScotland (UK)Tel: +44 (0)1358 [email protected]

www.powerjacks.com51Introduction1.2 RotatingCongurationsMotor AdaptorCouplingDrive ShaftGearboxTrunnion FeetRotary Limit Switch AdaptorBellows Boot

6www.powerjacks.com1Introduction1.3 IntroductionC-Series screw jacks are exclusively designed for carrying out linear motion movements in accordance w

www.powerjacks.com71.6 Operating Personnel1.6.1 The C-Series screw jacks are designed according to state-of-the-art technology and are in line with

8www.powerjacks.com2.0 Example1 2 3 4 5 6-7 8 9 10-11 12 13 14-15 16 17 18-19 20 21 22-23 24 25C M T 0 2 5 - 0 7 5 0 - T B 1 1 - 0 0 P T - 0 0 0 B - 3

www.powerjacks.com9Screw Jack Model4CM-010 CM-025 CM-050 CM-100Capacity (kN) 10 25 50 100Lead Screw1Diameter (mm) 20 30 40 55Lead (mm) 5 10 6 12 9 18